Machines, Programs and Tools

Mac computer, screen, IPhone, GitLab, HTML site, patience.

introduction

This is the harness part of the final project. The Harness is the part that attaches to the backplate and secures it to the body.

Projects

PrusaSlicer printing panel

A view of parts. The harness connector I reduced by 10% to make it small enough to fit between the breasts.

  • Thingiverse
  • Harness_Connector_2
  • Boot_Tab
  • Thingiverse
  • Swivel_Buckle_f1in
  • Swivel_Buckle_m1in

    • Harness assembled

    The Harness assembled with all parts.I used Bison glue to glue the ribbon together.

    Backview of all parts

    Summary

    I found most of the parts I needed on thingiverse and only had to alter them slightly to fit to my needs. I used silk ribbon for the harness itself, but Im still looking for a replacement that is better. Something with a little stretch in it but not too much. Then I will reduce the boot tab so the holes fit perfectly. I figured out how I wanted the harness to be and how it would be hidden the best under the costume. It can always be ajusted to get a confortable fit and is easy to remove.

    >