Richard Shan - Fab Academy Documentation

Group Project

Richard Shan - Fab Academy Documentation

Home
About
Final Project
Documentation
Documentation
- Pre-Fab
  Pre-Fab
- Week 1: Principles and Practices, Project Management
  Week 1: Principles and Practices, Project Management
- Week 2: Computer-Aided Design
  Week 2: Computer-Aided Design
- Week 3: Computer-Controlled Cutting
  Week 3: Computer-Controlled Cutting
- Week 4: Electronics Design
  Week 4: Electronics Design
- Week 5: 3D Scanning and Printing
  Week 5: 3D Scanning and Printing
- Week 6: Embedded Programming
  Week 6: Embedded Programming
- Week 7: Computer-Controlled Machining
  Week 7: Computer-Controlled Machining
- Week 8: Electronics Design
  Week 8: Electronics Design
  - PCB Design
  - PCB Production
  - PCB Soldering
  - PCB Programming
  - Group Project Group Project
    Table of contents
    
    Group Assignment
    
    Individual Contribution
  - Reflection
  - File Downloads
- Week 9: Output Devices
  Week 9: Output Devices
- Week 10: Mechanical Design and Machine Design
  Week 10: Mechanical Design and Machine Design
- Week 11: Input Devices
  Week 11: Input Devices
- Week 12: Molding and Casting
  Week 12: Molding and Casting
- Week 13: Networking and Communications
  Week 13: Networking and Communications
- Week 14: Interface and Application Programming
  Week 14: Interface and Application Programming
- Week 15: Wildcard Week
  Week 15: Wildcard Week

Week 8 Group Project

Group Assignment

For this week, our assignment as a group was to:

Use the test equipment in your lab to observe the operation of a microcontroller circuit board
Document your work on the group work page and reflect what you learned on your individual page

My full documentation for this project can be found here.

Individual Contribution

I was responsible for conducting oscilloscope readings on the blinking LED, conducting oscilloscope readings on the dynamic brightness LED, writing the C++ program for the blinking LED, writing the C++ program for the dynamic brightness LED, analyzing the oscilloscope readings, and documenting our work.