Final Project¶
My final project will be a reading light with a gooseneck with two buttons one to cycle through color and brightness and another one to turn it on and off.
Design Processes¶
The gooseneck will be made by 3d printing a bunch of my design below and putting armature wire the the holes on either side.
Piece of Gooseneck
Im going to laser cut a box that will hold the board and wires. will put design here when fully designed.
Electronics¶
The board that I will be using for my final project is this one. It has through holes for the buttons,neopixels,barrel jack connector, and switch. It will use an Attiny 1616 as the chip.
Final Project Board
List of Materials¶
Female barrel jack adapter,$8.49
Last update:
May 27, 2022