Skip to content

Final Project

Potential project Ideas

I have had quite a few project ideas which are as follows:

  1. Prosthetic which can measure grip force
  2. Hand Shake improver(based on the same technique as above)
  3. Lamp which unfolds when it senses presence
  4. Slim credit card size drone with single rotor
  5. Robotic sting ray or snake
  6. Fog based hologram
  7. Harati(Aarti) Drone

Finally I have finalized on the following Project

Shoto Pad:

A Coaster which can heat a cup of coffee or cool a cool drink can using a peltier effect module.

Taking inspiration from the character Shoto Todoroki from Boku No hero Academia whose quirk is Half hot-Half cold I came up with this project.


Initially I uderestimated the peltier module in ever way imaginable starting from it power requirements, size, heating and power efiiciency even the time it takes to show the results.

2D and 3D Modeling

Concept Sketch


Some other section

This is an updated text.


Qty Description Price Link Notes
1 Material one 22.00 $ Order many
1 Material two 22.00 $
1 Material three 22.00 $
1 Material five 22.00 $
1 Material eight 22.00 $
1 Material twelve 22.00 $
1 Material eleven 22.00 $

Code Example

Use the three backticks to separate code.

// the setup function runs once when you press reset or power the board
void setup() {
  // initialize digital pin LED_BUILTIN as an output.

// the loop function runs over and over again forever
void loop() {
  digitalWrite(LED_BUILTIN, HIGH);   // turn the LED on (HIGH is the voltage level)
  delay(1000);                       // wait for a second
  digitalWrite(LED_BUILTIN, LOW);    // turn the LED off by making the voltage LOW
  delay(1000);                       // wait for a second


From Vimeo

Fab-20190508B_Review14: mechanical design from Academany on Vimeo.

From Youtube

3D Models