Assignment 7: Electronics Design

Toughest assignment for me because I am not an electrician. So, I struggle a lot with understanding Eagle, knowing the components names, understanding the logic in this and to finally do my PCB in the milling machine.












Then, I export my file to PNG into two types, deselect some layers, after, board traces and cut out board, so I can mill it on the miller machine. Here you will find the sequence.




Now I was ready to mill my PCB board, I opened the archive (png) both of them on the milling software, assign the parameters for milling traces, previously mounting the PCB on the milling bed, then cut out the board, after changing the mill, and finally extract the pcb from the milling bed.










So, I took a couple of snaphots of my electronic design diagram in order to have it for soldering. Then I went to Photoshop to put both in one single image. Finally I got my diagram.



Then I start the soldering thing, finally I got it, but didn't test it yet.