logo academy i3d
SIXTEENTH WEEK ASSIGNMENT
home about assignments finalproyec

MECHANICAL DESIGN

 Assignment

Propose a final project that integrates the range of units covered.
Projects can be separate or joint, but need to show individual mastery of all of the skills
Where possible, you should make rather than buy the parts of your project

Here is the link to the website group "Machines assignment".

 

 WEBSIDE GROUP


courtesy of Claudia Aguilar


I had the responsability to implement the system Nichrome wire cutting, 0,13mm in diameter and 30cm long.

 The first test I did with a 9V battery.

Our machine has worked with a regulated source 12VDC and 0.5A was enough to cut.

If the speed was increased was 2 possibilities; Increased Volts, or cut out the points of contact with the wire.

<==  PREVIOUS  -                                 -   ASSIGNMENTS   -                                   - NEXT  ==>