• Week One
  • Week Two
  • Week Three
  • Week Four
  • Week Five
  • Week Six
  • Week Seven
  • Week Eight
  • Week Nine
  • Weeks Ten and Eleven
  • Week Six

  • Production Steps

    • Components
    • Labeling
    • Connecting
    • Traces
    • Converting

  • Production Steps Explanation

    • First I had to add the required compenents into Eagle.
    • Then I had to label them.
    • After that I connected the components into a led-button circuit.
    • Before I could export I had to route the traces.
    • Finally, I exported as a png and used GIMP to convert to a millable file.

  • Electronics Design

    This week I made a led-button circuit after using Eagle to design it. I added, labeled, connected, and routed the neccesary components. Once I had converted my design into a millable format I milled the circuit and soldered the components to it.

    I used the converted design file to mill the board.

  • Home
  • About
  • Project