-
Production Steps
- Milling
- Soldering
- Programming
- Testing
-
Production Steps Explanation
- First mill the traces using a 1/64 bit and then cut out with a 1/32 bit.
- Solder the components to the board.
- Install the required libraries, connect the board to the programmer, and run the make file.
- Desolder the 0ohm resistors and plug the board into a computer. If it shows up it is working.
-
Electronics Production
This week I made a fabISP circuit board. I milled the board using a Roland Modela and soldered the compenents to the board. It took me three weeks and 5 boards to get the fabISP made and programmed correctly. The upside to this is that I got lots of practice soldering.
One circuit failed due to bad connections to the USB pins.
However, the next circuit programmd successfully.