This project is born for necessity. Most of my work with the CNC router needs to be refined and some works can't be totally made with the CNC. When it comes to make tenons, some joints and in general all the border works, the CNC router is not the best option. Rotala is the answer to some of my needs. I already built a very basic router table but the manual setup of the parameters is time consumig, internet is full of nice manual DIY projects, but almost all cannot solve completely my needs. For Years I took part to woodworking forum, and there is a good interest to DIY woodworking projects, so my "dissemination" plans will start there: the woodworking forums around the world :-). Fab Academy's site is a dissemination place too, and I think to launch also a crowfounding campaign. The idea for this project is to release it as Creative Commons CC BY-SA ( Attribution, Share Alike) and distrubute all the information to help built it in a dedicated blog. As some parts could be difficult to made outside a FabLab comunity, I plan to make some kits of the most complicated parts and reinvest the income in upgrading and developing this project ( as Fiore Basile said, a good project is never finished :-) and some other I have in mind .... like a metal bender, a bit sharpner have a look at my Pins on metalworking ... or some woodworking tools like a portable sawmill, a thikness sander .... oh, but those are just old ideas when I did not knew "how to build almost everything" :-)