Group Assisnment Week 3 - Computer Controlled Cutting

Write something at the front

This is the machine where we are going to do the cutting:

The brand is Da Zu Yue Ming CMA1610.

The assignment is including tasks below:

We are going to use the acrylic board to do the cutting, for the first we need to know the thickness of it:

It is about 3mm, so on the Onshape I need to design a test board for testing the curf of it. Then I can make sure this board will be complete fit:

I design a board from 2.5mm to 3.1mm:

but it is a little no in the order, so I add some Variable Parameters:

for the width I think 1.5mm is fine.

Then I add the different cutting intervals as 1.5mm.

for the heigh I think 8mm is fine.

Then I add the different cutting intervals as 8mm.

Since the software for machine seems not supporting editing different contents, I have to make two layers for it cutting.

Then I output two DXF files:

And send them to the machine

note

The parameter is 95 Maximum light intensity, 90 minimum light intensity, 20 mm/s working speed.

And the power is 91.

Then I should have torn the paper off the acrylic sheet so it wouldn't catch fire:

Setting the zero ppoint:

Finally, setting the power of laser as 90%, and the speed as 20mm/S, as recommended before.

The I can send the file from the software to the machine and begin the cutting:

The first is brkoen and the second one is great:

But it also gave me a chance to see which one would fit right in:

I forgot to cut the text first. But after checking with the files I design, the curf should be 0.6mm.