Niel says...

There were many smart helmets in the past, but this one is one of the better ones!

Rodrigo says...

Remember, what you want to do, what you can do,and what you have to do, should be considered.

I say...

Well, that's that~



Night Fury Code

PCB Trace

PCB Hole


PCB Schematics

PCB Board

PCB Casing 3Dprint


Final Project: Smart Helemet


I decided to change my Final project in Week 6 because I was very inspired by the movie,
'How to train your Dragon 3" and I really liked the sketch I drew from that.

Using Fusion360, I rendered a couple design.

Making the Helmet.

    The layers that make up the Helmet part
  1. Composite: Resin Burlap (Week 18)
  2. Leather Sewn On
  3. Neopixels (Week12)
  4. Casted Spikes (Week 10)
  5. Leather belt
You can check out Step by Step of what I did in [Week 20].



Molding and Casting


Bill of Material
  • Atmega 328P
  • 0.1uf Capacitor
  • 1uf Capacitor
  • 10uf Capacitor
  • 10K Resistor
  • 499 Resistor
  • 8.00 Resonator
  • LED Orange
  • FTDI Connector
  • ISP Connector
  • Reset button
  • Switch
  • LIS3DH Acclerometer breakboard
  • 3.7V LI-ion Battery x2


From my struggles I found a simple public accelelrometer example with neopixels by Tony Dicola.
I adapted his code and customized it with my project, adding on prequisites.
I hope to develope it more to work with photoresistor and have better input reading.

[Check out my sidebar for code download.]