Electronics Design | Week 07

Week Content

Tools Used

Eagle 8.0.2 | Download (Education Version) | 98 MB

Install Eagle
Add fab.lbr to eagle library.
Add components connect circuit.
after connecting each component and removing Errors go Boards
After that Components to arrange and check for routing
After that evaluate circuit layout and check if wire is not connect in layer ( After trying i found one was still not connecting I am going to use jumper wire
After that go for export of that Circuit
Export in Monochrome and 400 DPI Resolution (Its Important )

Component List

ATtiny 44
6LED's
2 Buttons
2 - 10k Ohm Resistor for Buttons
1 - 10k Ohm Resisstor between RST and VCC
1- 22uF Capacitor between VCC and GND
6 - 1k Ohm Resistors
3 - 0 Ohm resistor in place of jumpers

To Add components click on add and select according to company

There are different layer to show while making connection for circuit which guide better to make connection properly.

After that you have switch connection to Board were you will find layout of each component is added and you can move according to it
Try to make is as good and easy so routing will be that much accurate.

If you still find it is to be adjusted and few thing you can do is connect "0" resistor to jump any single line

Error Can be check and removed after connection of components

In Routing you have to do some edit in NET Classes from DRU file you are using.
We are using FAB DRU and change that value to mils. ( In Eagle it directly takes as mm).
After that keep top as Auto and bottom as N/A ( I forget to do this in starting)