LASER CUTTING
OPTION 1
To develop laser cutting exercise first wanted to find fabric geometric pattern of Chiapas where I found diamonds and triangles square and draw in autocad frets
Draw the geometric pattern found in a single module in autocad, then repeat a number of times and play the part.
This is a drawing of a piece on and then multiply
This is the part that I'm sending to cut once has multiplied in drawing
These are the first pieces that I will remove the cutting and which result from the geometry of Chiapas mats
The pieces that I will not use
Who uses geometric patterns for assembling my cubes
Affluent parts horizontally
The first adjusting parts armed node cube faces
Two Pieces Together
Assembly the cube
The geometric pattern to assemble
Begin assembling the cube on one of the mats Chiapas
View from the top table where the geometry is clearly being studied
OPTION 2
This same geometry was placed in another acrylic material which was, but here only the part was recorded geometry. The pretended node outside the central cutting perform.
I drew it again in autocad
These are the images where cut.
It instructs the computer to be recorded.
It starts in the laser cutting
The end result of the cut.
This is the result of laser cutting, the pieces of the middle part are those that serve to clamp the node faces.
These are the pieces I will use to the node
Here I am putting the pieces of the way for the union of the nodes
This is the union of two faces
This is the union of three faces
This is the central cube with nodes
The cube with one of the covers
Full cube
You can start to form an any direction cubes
We put chocolates in colored spheres in the center to give a use
With chocolates
Final work
