2014
MOLDING AND CASTING
![face](images/molding.jpg)
Molding started of with a red light as our urethane mold compound had ran the course of its shelf life meaning I had to find an alternative to that. Modeling clay looked to be a good replacement.
![face](images/molding3.jpg)
I designed the model using coreldraw in to 2D after which I converted to 3D/2.5D using partwoks them machined the part out.
![face](images/molding7.png)
![face](images/molding8.png)
![face](images/molding9.png)
![face](images/molding2.jpg)
I then created a negative of the design on the modeling clay after which I powered in the hydrostone paste and after a couple of minutes it was done.
![face](images/molding4.jpg)
![face](images/molding5.jpg)
![face](images/molding6.jpg)