2014
COMPOSITE
For the composite assignment I create the at symbol on the shopbot on a .75" inch MDF board engraved to a depth of .4"
![face](images/composite.png)
![face](images/composite.jpg)
![face](images/composite2.jpg)
![face](images/composite3.jpg)
Absence of fibreglass and resin required creativity on what to substitute them with. With a little of searching I came across this and that tried out these as alternatives
![face](images/composite4.jpg)
Mixed three parts glue and one part water
![face](images/composite5.jpg)
![face](images/composite6.jpg)
used a layer as the release :) bad idea as it got stuck on the mold. So I tried tape.
Results.... Not that great but better than the last one.
![face](images/composite8.jpg)
top
![face](images/composite9.jpg)
bottom
Downloadsshopbot engrave
engrave cut-out
partworks file