- Make Mission T-shirts, stickers, notebook
- Make the fiber glass tube and make it as a reference design foundation
- Use open rocket software and to draw the block diagram of the spaceship
- Simulate the Design With fluid analysis tolls (RasAero)
- Use Fusion 360 to make the design fabricable based on the foundation tube
- Laser cut the engine Mounter and Fins Center Rings
- Mount the fins on the fiber glass tube
- Mount the PVC engine and make sure it is stable with a lock ring
- 3D print the space ship nose
- Sand the nose and fill it and sand again then paint it with acrylic paint
- design the mother board of the starship: Servo, Altitude meter, IMU Remove before flight sys, Sound Indicator, led Indicator
- Design and build the mechanical Parachute Deployment mechanism
- Test the Deployment mechanism: title Angle | Altitude
- Make the wire system between stage one and two
- robe mounting on the parachute
- test the parachute + Electronics system +Deployment mechanism
- 3d print the rail rings and mount them on the spaceship