This week, I worked on creating something using a digital fabrication technique that hadn't been discussed in the prior weeks. While doing so, I listed the standards my assignment satisfied and provided all the information needed to duplicate it.
Here below is the designed holder in soldworks:
Below is the designed internal cell to split rooms inside the container:
Covering the holder with a tissus to hold concrete substances:
Applying concrete substances to the tissus:
Drying the concrete
Extracting the cup, in order to remain with concrete only
Cutting unwanted parts
Doing coloring to apply yellow on the concrete
Here below is the made concrete pen holder
Here below is the corelDRAW designed box parts:
Cutting
Cutting parts using CNC
Doing assembly of the box
Powering the pump moter with 12v Power Supply Adapter
Adding the bottle of water which is going to serve as water container
Cutting the bottle of water to accumulate dropping down water
below is the hero shot
© 2023 | Eric NDAYISHIMIYE | All Rights Reserved