Skip to content

- MDX-40A, V Panel

This is the page to use VPanel.
Paying attention to Group work "Kitakagaya: Week8 Electronics Production" about feed rate, spindle rate, and origin, then Proceed below process.

Process

  • Fixtured the board to spoil board (sacrificial layer). alt text alt text

    • NOTE: In FabLab West-harima, Acrylic double-sided tape in 100 yen shop is used. alt text

  • Set chuck (Depend on mill size, change Chuck) alt text

  • Mill set alt text

  • Set Z Probe and click button to set the Z origin. (NOTE: Z Probe set = tool path origin) alt text
    alt text

  • Set X0 Y0

    • Move the mill to the XO and YO position. alt text
    • And click button "Set XY origin here" alt text

  • Spindle Speed If the Spindle Speed rpm is not reflected with tool path, change rpm on V panal. alt text

  • File upload alt text

    • If the upload file is remain, "all file delete" and "add file" and click "output". (Automatically, start machining ) alt text

  • Milling start alt text

  • Finish Milling

  • Vacuum alt text
  • Take off the board from spoil board (sacrificial layer).
  • Take off the mill.
  • Done!