Skip to content

Overview

Subject Pages

The elctronics section has several pages dedicated to the topics we encountered. They are listed below.

Electronic Connections

I’ve made a separate page for all aspects of making electronic connections. This includes soldering, connectors, harnesses etc.

Measurement Equipment

This page is about the measurement equipment we have available at De Waag. It was part of week 2 group assignment to have a look into them and learn how to use them.

Electronic Design

Page about schematics and PCB design for electronics. I used KiCAD for the assignment of week 6 to redesign the hello-world board.

Input & Output

Because input and output are related - usually u use an input device to control an output device - I have combined these topics on one page.

Settings

Some settings are important to have at hand. The main item here are the settings – aka design rules – for the lay out in KiCAD.

parameter value unit remarks
normal trace width 0,2 ~ 0,4 mm 0,4 is standard, for dense boards go to 0,2
power trace width 1,0 mm optional to be filled with solder for extra conductance
distance between traces ≥ 0,4 mm for trace milling bit of 1/64” (0,3969 mm)
via for PDIP diameter 0,6 mm e.g. for gate driver
via for PDIP drilling hole 0,8 mm
via for TO-220 diameter 1,0 mm e.g. for mosfet
via for TO-220 drilling hole 1,4 mm

Last update: June 22, 2022
Back to top