General objective (group assignment):
- Compare the performance and development workflows for other architectures
Development
Once again we are doing this assignment. We, ve already done it on 2020, then upgrade it to 2021. And now for 2022 we’ve included the new gen, although with the MCU shortage Worldwide we only have SAMD11C to test.
Here in Fab Lab Querétaro analized the older generation as well as the new SAMD11C.
First we downloaded the datasheets from the website and Studied the first pages and compare them.
References:
Then we made the comparison between the older group assignment and the new samd datasheet. And include it to the table.
This is a table we did on 2020 to compare the basic differences between the atinny MCU’s we still have in our lab while we wait for the newer gen to arrive. And the samd11C we just got.
PIN OUT attiny44/84/45/85
Referencia: https://arduino.pinout.guide/attiny_generic_pinout_and_ISP_pins.png
PIN OUT atmega328p
Referencia: https://arduino.pinout.guide/atmega328_pinout.png
I recommend looking this page to more info about arduino’s pin out in general It’s a lot more simply to look at graphics than to guess wich pin is what.
SAMD11C pinout
Referencia: https://gitlab.fabcloud.org/pub/helloworld/index/uploads/3b1082bbcbf4494912f4b1241c85d63f/SAMD11.jpg
This is a really Good made from Adrian Torres at fab Lab Léon it explain really well the pin out diagram on the SAMD11C chip he used on his SAMDINO board.
https://gitlab.fabcloud.org/pub/helloworld/index/-/tree/master/SAMDino.%20Hello%20SAMD11C14
Conclusion
We are looking forward to made new isp’s and project boards using this new gen. for the documentation we saw and read it looks a lot easier to implement.
