HASHEM JOUCKA

Projects

HTML tutorial

Electronics Production

  • Date: February 19

Assignment: Make a FabISP in-circuit programmer.

1) Printed Circuit board: Milled the board traces and interiors on the Roland Modela milling machine using the Fab Modules. Click here for tips on using the modela to mill PCBs.

1) Printed Circuit board: Milled the board traces and interiors on the Roland Modela milling machine using the Fab Modules. Click here for tips on using the modela to mill PCBs.

2) Assembly: Soldered the components on the circuit board accodring to the FabISP labeled board diagram.

3) Testing: I connected the FabISP to my computer via mini USB cable. ( No smoke/ error). However, when the FabISp was connected to the USBtiny, it showed a red light indicating error. I tried to troubleshoot the problem with no luck so I had to make another FabISP.

4) Programming: Downloaded and installed the necessary software for AVR programming (Avrdude & GCC). Connected the FabISP to a USBtiny programmer (6-pin header) and to my computer. Programmed the board.

5) Testing: The FabISP was finally recogined by my computer.

PCB Fabrication
Project 01a
PCB
Project 01c
Soldering components on board
Project 01c
FabISP
Project 01c
Programming