Output Devices
Group AssignmentThis weeks the group assignment was to measure the power consumption of a motor withing a circuit. We measured the voltage of the circuit in different conditions with a multimeter. This helped me understand what conditions the circuit I created needed to have in order to run smoothly.
Using My Developement Board
Using Arduino IDE, I chose the board ESP32, and changed the port to XIAO. I used a code that programs the LED to blink. I then uploaded the code to the devlopement board. I then disconnected the board and constructed the breadboard with the LED, 220 Ohmm resistor, and two wires. I connected the LED to pin D10, and reconnected the board to the computer. The LED began to blink! My luck granted me an easy week!