Mold and Casting
Here I explain how I made the protective Flower and how I install them on the ends of the main stick.
![](../images/FinalProject_doc/f0.png)
![](../images/FinalProject_doc/f1.png)
However the result lacked in thickness in my opinion, so I repeated the cast increasing the Z-dimention of the previous moldes directly in Cura.
![](../images/FinalProject_doc/f2.png)
I finally I merged the old cast and the new one as shown in the picture above.
I then made an hole in the center in order to insert the screw to screw into the 3D printed holder.
![](../images/FinalProject_doc/f3.png)
This is how is done:
And this is the final result on both sides.
![](../images/FinalProject_doc/f4.png)