Electronics Production


I decided to make a Hello.ISP.44 board using Attiny 44.


  • PNG files can be received here traces, interior
  • I used an illustrator to add my name to the png file.
  • week4



  • The PNG file was converted to an SVG file that can be opened in a milling machine program.
  • week4



    Bantam was used to mill PCB boards.


    week4



  • cleaned the copper plate and the machine.
  • week4



    week4



    week4



  • The thickness, height and width of the copper board to be used were measured.
  • week4



    week4



    week4



  • After completing the measurement, attach a double sided tape to the back of the copper plate and finish the preparation.
  • week4



    week4



  • Enter measured values into the Bantam program.
  • week4



  • Milling in the wiring section used a 0.4mm end mill.
  • week4



    week4



    week4



  • I changed the endmill and pressed the change tool to set the Z axis of the changed end mill.
  • week4



    week4



    week4



    week4



  • The operation was executed after changing the end mill.
  • After the work, I cleaned up and checked the board status.
  • week4



    week4



    week4



  • changeed the end mill to 0.8mm and Cut the outline.
  • week4



    week4



    week4



    week4



    week4



    week4



    week4



    week4



  • Clean the copper plate and check with a multimeter.
  • week4



    week4



  • Solder the copper plate after checking.
  • week4



    week4



    week4



    week4



    week4



  • But what I made was not this week's assignment I work on it again.
  • week4



    week4



    week4



    week4



    week4



    week4



    week4



    week4



    week4



    week4



    week4



    week4



    week4



    week4



    week4



    week4



    week4



    week4



  • And I tried the FabISP Production and Programming tutorial.
  • tutorial here

  • But WinAVR was abandoned and I tried with Ubuntu with the help of my teacher Craig Hobern.
  • week4



  • I followed the tutorial.
  • week4



    week4



    week4



  • But I kept failing to recognize the USB device and install the driver.
  • week4



  • I couldn't solve the problem and I making a new board. (my bad soldering)
  • week4



  • I followed the tutorial again with a new board.
  • week4



    week4



    week4



    week4



  • Finally recognized the board and installed the driver.
  • week4



    week4



  • Remove the solder bridge
  • week4



  • I came back to my Windows laptop and tried to program it as Aduino, but there was a new error.
  • week4



    week4



  • Craig thought it was a problem with Windows, suggested returning to Ubuntu to try out the program.
  • week4



    week4



  • Finally I could get a purple LED.




  • my work
  • isp File here

    ispline File here

    RGB eps File here

    RGBline eps File here