3D scanning and printing

Group Assignment:

So I didn't have a lot of resources but I found a standard test of Thingiverse that can provide me with the limits of the printer.

Print Settings

Printer:

CubePro DUO

Rafts:

No

Supports:

No

Resolution:

100um

Infill:

100%

Notes: BE SURE TO PRINT THIS WITHOUT SUPPORTS AND WITH 100% INFILL!

I used Ultimaker 2 extended for printing this part and the printer quality was very amazing

but still, there were 2 problems the overhang was perfect at a 50-degree angle but after that, it starts to oozing and I think that can be fixed easily by lowering the layer height and the printing temp
Next, the small words weren't very clear I think if I use a smaller nozzle it will be more clear but it will take more time to finish

also, I found this article to explain more problems and how you can fix them.

Files.