week 3
week three
I started with the preparation of my sticker, maybe what I wanted to see materialized was a bit complex to do it in fusion 360, I could not join the points of the curves and parameterize them, when the project finished apparently and exported to silhoutte they did not appear Certain lines of my design.
I ended up using inkscape to complete the final details of the figure I wanted to cut.
I started to cut the sticker on the silhoutte, I took out the parts I wanted to paint and since I didn't have transfer material I used masking tape, which made it a little more difficult but I finally achieved what I was looking for
As for the parametric design and the joints, I wanted to make a piece that could be repeated by creating panels, my project unfortunately was not successful, since the surface remained flat, however I also designed another additional piece with snap to give volume to the piece.
