This week I made two things:
- desk for standing work on laptop
- standing table with adjusted height
First of all design process
![](../../images/week08/design1.png)
![](../../images/week08/design2.png)
![](../../images/week08/design3.png)
![](../../images/week08/design4.png)
![](../../images/week08/design5.png)
![](../../images/week08/design6.png)
Attention on that circes in corners, it is very important to fit later
Here is parameters of the cutting:
The only one problem I faced with – it’s too high feedrate speed, in result one endmill was broken. I reduced speed to 500 mm/min and it worked pretty well.
Cutting:
![](../../images/week08/5.jpg)
![](../../images/week08/3.jpg)
Final view after assembling:
Files:
Detail 1 vector Detail 2 vector Detail 3 vector Complete sketch G-code for milling
Additionally, I found somewhere in Pinterest cool stand table, and tried to accomplish it:
Cutting:
![](../../images/week08/6.jpg)
![](../../images/week08/7.jpg)
![](../../images/week08/8.jpg)
![](../../images/week08/9.jpg)
![](../../images/week08/10.jpg)
![](../../images/week08/11.jpg)