Planning circuit

For this assignment I will use week 10 board as a base. Will replace both LEDs and button with a RGB light. Will keep FTDI and 2x2 header for networking assignment.

Simulation

Using week 11 simulation as base, I replace both LEDs and button with a RGB light

The bill of materials used here is: (without FTDI and 2x2 headers)

• Attiny45 x1
• Red LED x1
• 1uF Capacitor x1
• 10k Ohm Resistor x1
• 1k Ohm Resistor x2
• 499 Ohm Resistor x1

Programming

After connect everything, we add the code for this proyect. It is important to note that since we are working with an RGB, we need to use the "PMW" pins to regulate color. If we only use digital output, we could only get solid colors and mixes between them. However, pinout from tiny45 indicates we only have 2 pins for PWM work (pin 0 and 1), meaning green (pin 2) can only be used as solid color.

First part of the code is to set the pins I'm using to connect RGB LEDs. On setup function, pin are set as an output.

Now we jump to "colordef" function. There color parameters are created (red , green and blue) and set to be the parameter for the "analogWrite" function.

In loop, colors decided to light are defined. And that's it.

Can find the simulation here

Design

Using week 11 schematics as base, I replaced the LEDs and their resistors, the button and it's pullup resistor; with a RBG LED and 3 resistor on each leg. Similar to that week, 2x2 headers are used to later comm work.

Repeat same steps as week 11.

Milling and soldering

Same procedure like last week.

After milling noticed some tracks were connected! Used a cutter and then cleaned with a toothbrush. Also, due to the use of a broken 1/64 tool, the board had some debri on it. Had to remove with a lime.

Soldered, and continuity test. Everything was ok.

Programming

I only need to load the simulation programm to the tiny. But need to change the pin number to match the ones on the board.

"redPin", "bluePin" and "greenPin" are changed to 0, 4 and 3.

Soldered, and continuity test. Everything was ok.

Files

Simulation can be found here.

Eagle design can be found here.

Code files can be found here.