I revised these sources with Codex assistance for two XIAO RP2040 boards using
Arduino-Pico core 4.5.3. The old archived sketches remain unchanged. The folder
name refers to source/build checking, not a verified physical network.

Both boards: D4 (GPIO6) = SDA, D5 (GPIO7) = SCL, common GND, compatible supplies.
The bus uses 3.3 V logic. Identify existing pull-ups before adding more; use
suitable pull-ups to 3.3 V for the actual wire length and bus capacitance.
Sender touch input: D9 (GPIO4). Receiver LED: D1 (GPIO27), verify board polarity.
At least one node must be a personally designed and fabricated board.

Protocol: address 0x08, one byte, 0=released/LED off and 1=touched/LED on.
The sender logs Wire.endTransmission(): zero is bus acknowledgement; nonzero
means an error requiring investigation. ACK alone is not proof that an LED moved.
The receiver rejects wrong lengths or values and applies valid messages in loop,
outside the receive callback. Both serial logs use 115200 baud.

For an addressing test, change MY_ADDRESS to 0x09 on the receiver only: the sender
at 0x08 should no longer receive that receiver's acknowledgement. Then change
RECEIVER_ADDRESS to 0x09 and retry. Record both logs and the physical output.
This is a planned test; no successful transfer is claimed by these sources.

Core reference: https://arduino-pico.readthedocs.io/en/latest/wire.html
