I kept the archived 0/90/180 degree sequence and added USB command logs with
Codex assistance. This is a new source version, not proof of a repeat bench test.
Target: XIAO RP2040, Arduino-Pico 4.5.3 and its bundled Servo library.

SG90 signal -> D9 (GPIO4). Servo power -> a suitable identified 5 V supply;
servo ground and controller ground must be common. The GPIO is signal only.
Check the actual servo and mechanism travel before using the full sequence.
Serial Monitor is 115200. Logged angles are requested values, not measurements.

Record the supply identity, board revision and observed response during the
physical retest. The group current figures are not individual measurements of
this source version. The original sketch remains available on the weekly page.
