I prepared this replacement with Codex assistance because the original
TouchSensorLib.h dependency was not archived. It is not the original library.

Target: XIAO RP2040; Arduino-Pico core 4.5.3. No extra libraries.
TTP223 VCC -> 3V3, GND -> GND, digital OUT -> D9 (GPIO4).
Existing board LED -> D1 (GPIO27), subject to the actual LED circuit polarity.
Use Serial Monitor at 115200. Stable touch/release transitions are printed after
30 ms. This is a digital switch state, not a capacitance value.

Check whether the module is momentary/toggle and active-high/active-low. Change
TOUCH_ACTIVE_HIGH for an active-low module. The module must provide 3.3 V-compatible
logic. I still need to record its actual supply, touch/release response and board
revision in a physical retest. A compile check is not that retest.
