ARCHIVED LDR/LED BOARD — NETLIST REFERENCE Generated from the archived schematic with KiCad 10.0.7. This is file connectivity, not a measurement or a confirmation of the soldered board. Net-(D1-A): D1.2 (A_2), M1.15 (GND_15) Net-(D1-K): D1.1 (K_1), R2.2 (passive) Net-(M1-D0): M1.1 (D0_1), R1.2 (passive), R3.1 (passive) Net-(M1-GND-Pad13): M1.13 (GND_13), R3.2 (passive) d1: M1.2 (D1_2), R2.1 (passive) d2: J1.1 (Pin_1_1), M1.3 (D2_3) d3: J1.2 (Pin_2_2), M1.4 (D3_4) d4: J1.3 (Pin_3_3), M1.5 (D4_5) d5: J1.4 (Pin_4_4), M1.6 (D5_6) d6: J3.1 (Pin_1_1), M1.7 (D6_7) d7: J2.1 (Pin_1_1), M1.8 (D7_8) d8: J2.2 (Pin_2_2), M1.9 (D8_9) d9: J2.3 (Pin_3_3), M1.10 (D9_10) d10: J2.4 (Pin_4_4), M1.11 (D10_11) unconnected-(M1-5V-Pad14): M1.14 (5V_14) unconnected-(M1-GND-Pad19): M1.19 (GND_19) unconnected-(M1-RESET-Pad18): M1.18 (RESET_18) unconnected-(M1-SWCLK-Pad20): M1.20 (SWCLK_20) unconnected-(M1-SWDIO-Pad17): M1.17 (SWDIO_17) unconnected-(M1-VIN-Pad16): M1.16 (VIN_16) v3: M1.12 (3V3_12), R1.1 (passive) The LED anode is on the module GND pad 15 in this archive. Its cathode connects through R2=220 ohms to D1. That does not implement the intended active-high LED circuit. R3 is recorded as 10 ohms. Compare both with the actual assembled board before correcting or fabricating another revision. Native ERC/DRC checks report unresolved issues; this is not a fabrication-ready approval. Original files are preserved without changing their recorded values.