{
  "case_width": [82, "Overall enclosure width; provisional"],
  "case_length": [128, "Overall enclosure length; provisional"],
  "case_height": [30, "Base height before the faceplate"],
  "corner_radius": [8, "Outside vertical corner radius"],
  "wall": [2.4, "Wall and floor thickness"],
  "face_thickness": [3, "Nominal laser-cut faceplate stock; measure actual stock"],
  "screw_inset": [6, "Case screw centres from the outside edges"],
  "boss_diameter": [8, "Case screw boss outside diameter"],
  "pilot_diameter": [2.6, "Starting pilot for plastic-compatible screws; test on coupon"],
  "clearance_diameter": [3.4, "Faceplate clearance hole for M3 hardware"],
  "oled_window_width": [31, "1.3-inch OLED viewing opening; confirm active area and glass"],
  "oled_window_height": [17, "1.3-inch OLED viewing opening; confirm active area and glass"],
  "oled_y": [91, "Display centre measured from the bottom end"],
  "oled_board_width": [35.5, "Generic 1.3-inch module envelope only; replace with measured value"],
  "oled_board_length": [34, "Generic 1.3-inch module envelope only; replace with measured value"],
  "oled_hole_pitch_x": [31, "Generic OLED hole pitch; not a verified module specification"],
  "oled_hole_pitch_y": [29, "Generic OLED hole pitch; not a verified module specification"],
  "oled_screw_clearance": [2.3, "M2 mounting clearance; check actual module"],
  "button_diameter": [12.2, "Starting opening for a panel-mount momentary button"],
  "button_body_clearance": [20.2, "Tray clearance behind the panel button; measure actual body and terminals"],
  "button_y": [25, "Button centre from bottom end; measure the switch body"],
  "tray_width": [64, "Removable electronics tray width"],
  "tray_length": [72, "Removable electronics tray length"],
  "tray_y": [52, "Electronics tray centre from bottom end"],
  "tray_z": [12, "Electronics tray lower surface above outside base"],
  "tray_thickness": [2.4, "Printed tray thickness"],
  "tray_screw_inset": [5, "Tray screw centres from tray edges"],
  "battery_width": [50, "Reserved battery envelope; not a purchased cell specification"],
  "battery_length": [30, "Reserved battery envelope; not a purchased cell specification"],
  "battery_thickness": [7, "Reserved battery envelope including allowance"],
  "service_width": [18, "Side service/cable opening along the case length"],
  "service_height": [8, "Side service/cable opening height"],
  "service_y": [45, "Side opening centre from bottom end"],
  "service_z": [20, "Side opening centre height"],
  "coupon_width": [30, "Small pilot-hole and wall print coupon width"],
  "coupon_length": [18, "Small pilot-hole and wall print coupon length"]
}
