Week 08 - Electronics Production

This week I made a PCB, that can be used to try out connection and communication via SDI-12. I use an industry-standard M12 connector with 5 pins, from which only three pins are connected.

(1) - +12V
(2) - SDI-12
(3) - GND

I also achieved to make a board, that can be powered from different source. In this case either by 5 V via USB for programming and setup or via 12 V, when in operation.

As by end of week 8 I was still waiting for the components for the level shifter to arrive. The aim is to test it during networking and communication week.