Structural Design

I started my fabacademy journey with this sketch of my final project.

Version 1

And the above sketch is changing to something else that looks quite different. Here is my new Sketch.

I started designing my NapPod in Blender as I really want to get comfortable with Blender and I have also invested a lot time learning it from the very beginning of Fabacademy. But it is quite hard to do parametric design in Blender (Geometric Node is very powerful but I am not yet there). So I modelled my NapPod in Fusion360 before switching up to Blender again. I did a rough design in fusion360 to turn my sketch into something tangible.

This design looks quite funny and I really have to think about how I can make it look better. At least better than this!

Version 2

This is new sketch based on which I will redesign and this time I will try to model it in Blender.

I am planning to put my speaker and NeoPixels as show below in my sketch.

Started designing my NapPod in blender. I tried to use Geometry Node but I could not really warp my head around it. So I try to model is in a normal approach.

Changed my design idea to something like this but I still didn’t like it a lot.

Version 3

Then I changed it to this one. I think this one looks quite good to me so I also made a cardboard prototype using Zund.

Card Board Prototype