#Blink

/*

        Blink

        Turns an LED on for one second, then off for one second, repeatedly.

        Most Arduinos have an on-board LED you can control. On the UNO, MEGA and ZERO

        it is attached to digital pin 13, on MKR1000 on pin 6. LED_BUILTIN is set to

        the correct LED pin independent of which board is used.

        If you want to know what pin the on-board LED is connected to on your Arduino

        model, check the Technical Specs of your board at:

        https://www.arduino.cc/en/Main/Products

        modified 8 May 2014

        by Scott Fitzgerald

        modified 2 Sep 2016

        by Arturo Guadalupi

        modified 8 Sep 2016

        by Colby Newman

        This example code is in the public domain.

        https://www.arduino.cc/en/Tutorial/BuiltInExamples/Blink

*/

// the setup function runs once when you press reset or power the board

void setup() {

        // initialize digital pin LED_BUILTIN as an output.

        pinMode(26, OUTPUT);

}

// the loop function runs over and over again forever

void loop() {

        digitalWrite(26, HIGH);   // turn the LED on (HIGH is the voltage level)

        delay(1000);                       // wait for a second

        digitalWrite(26, LOW);    // turn the LED off by making the voltage LOW

        delay(1000);                       // wait for a second

}