Computer Controlled Machining

After being indescive on what i wanted to for my final project, i finally came up with the green robot idea.

Research

As a computer science student ive always wantedto extend my programming skills into building real lice gadgets.

As an enviormentalist ihave always wanted to create and contributing in combating climate change.

Useful links

S

• Example link to page on this website
• W3 HTML chools (open in new window)
• GitLab Pages examples

Code Example

  // the setup function runs once when you press reset or power the board
  void setup() {
    // initialize digital pin LED_BUILTIN as an output.
    pinMode(LED_BUILTIN, OUTPUT);
  }

  // the loop function runs over and over again forever
  void loop() {
    digitalWrite(LED_BUILTIN, HIGH);   // turn the LED on (HIGH is the voltage level)
    delay(1000);                       // wait for a second
    digitalWrite(LED_BUILTIN, LOW);    // turn the LED off by making the voltage LOW
    delay(1000);                       // wait for a second
  }
  

Created my Furniture on Fusion360

At first i wanted to create this chair but it seemed a bit too compliacted.

Then i proceeded with this table, i created a flat square with four rectangles inside, then extruded it.

I later on created four legs that can fit into the tables holes.

---

S