'----------------------------------------------------------------
'SHOPBOT ROUTER FILE IN MM
'GENERATED BY PARTWorks
'Minimum extent in X = 0.000 Minimum extent in Y = 0.000 Minimum extent in Z = 0.000
'Maximum extent in X = 1820.000 Maximum extent in Y = 910.000 Maximum extent in Z = 15.000
'Length of material in X = 1820.000
'Length of material in Y = 910.000
'Depth of material in Z = 15.000
'Home Position Information = Bottom Left Corner, Table Surface 
'Home X = 0.000000 Home Y = 0.000000 Home Z = 35.320000
'Rapid clearance gap or Safe Z = 20.080
'UNITS:MM
'
IF %(25)=0 THEN GOTO UNIT_ERROR	'check to see software is set to standard
SA                             	'Set program to absolute coordinate mode
CN, 90
'New Path
'Toolpath Name = Drill 1
'Tool Name   = 1/4 inch Down Cut

&PWSafeZ = 20.080
&PWZorigin = Table Surface
&PWMaterial = 15.000
'&ToolName = "1/4 inch Down Cut"
&Tool =1           'Tool number to change to
C9                   'Change tool
TR,18000               'Set spindle RPM
C6                   'Spindle on
PAUSE 2
'
MS,69.7,34.9
JZ,35.320000
J2,0.000000,0.000000
J3,11.972074,871.378296,20.080000
M3,11.972074,871.378296,14.000000
J3,11.972074,871.378296,20.080000
J3,23.369915,19.312265,20.080000
M3,23.369915,19.312265,14.000000
J3,23.369915,19.312265,20.080000
J3,584.366089,40.468826,20.080000
M3,584.366089,40.468826,14.000000
J3,584.366089,40.468826,20.080000
J3,1129.246216,50.000000,20.080000
M3,1129.246216,50.000000,14.000000
J3,1129.246216,50.000000,20.080000
J3,1784.929199,28.263451,20.080000
M3,1784.929199,28.263451,14.000000
J3,1784.929199,28.263451,20.080000
J3,1774.486206,864.042786,20.080000
M3,1774.486206,864.042786,14.000000
J3,1774.486206,864.042786,20.080000
J3,910.000000,873.232117,20.080000
M3,910.000000,873.232117,14.000000
J3,910.000000,873.232117,20.080000
J3,697.506775,525.680908,20.080000
M3,697.506775,525.680908,14.000000
J3,697.506775,525.680908,20.080000
JZ,35.320000
J2,0.000000,0.000000
'
'Turning router OFF
C7
END
'
'
UNIT_ERROR:
CN, 91                            'Run file explaining unit error
END