Skip to content

18. Wildcard week

Hello! On this occasion, I will comment on the work done.

Research

When I was working with the laser cutter on my final project design with 5mm MDF material and engraving on the same material, I asked the colleague who has been supporting me if it could be engraved on a glass cup and a cup. of ceramics, the engineer told me if the engravings were made and we began to work on it and the following was observed, You have to set the parameters for scraping and engraving with precision and calibrate the laser and then run and tube the product. Here I show you my work this week.

In this process, the laser cutting machine is being coded to carry out the scraping and engraving of the executed design.

In this process, the diameter of the glass is being measured to calculate the design in the glass.

We proceed to turn on the laser cutter to carry out the work. At the end, the engraving on the glass of the executed design is obtained.

After having made the engraving on the glass, out of curiosity, it was decided to do the work on a gean cloth, the engraving with the entered parameters and it is observed that it also does the engraving, for it was a very satisfactory experience due to the work we carried out as a team and having the results.


Last update: June 15, 2023