Skip to content

Final Project

My final project is a water-saving device installed on the faucet. This is a project based on SDG. I explored this idea in an SDG training camp and hope to make it in kind through this study.This week I worked on defining my final project idea and started to getting used to the documentation process

Research

Function

  1. Monitor the water flow and temperature, and check whether they meet the national standards;
  2. Intelligent judgment of water use mode;
  3. Automatically control the flow rate and outlet form according to different application scenarios;
  4. Display the big data and ranking of daily water consumption and water saving of other users in the city and the country;
  5. Intelligently control the water temperature of the faucet and recycle the water that does not reach the water temperature;

2D and 3D Modeling

1645626344665.png

Some other section

This is an updated text.

Materials

Qty Description Price Link Notes
1 Material one 22.00 $ http://amazon.com/test Order many
1 Material two 22.00 $ http://amazon.com/test
1 Material three 22.00 $ http://amazon.com/test
1 Material five 22.00 $ http://amazon.com/test
1 Material eight 22.00 $ http://amazon.com/test
1 Material twelve 22.00 $ http://amazon.com/test
1 Material eleven 22.00 $ http://amazon.com/test

Code Example

Use the three backticks to separate code.

// the setup function runs once when you press reset or power the board
void setup() {
  // initialize digital pin LED_BUILTIN as an output.
  pinMode(LED_BUILTIN, OUTPUT);
}

// the loop function runs over and over again forever
void loop() {
  digitalWrite(LED_BUILTIN, HIGH);   // turn the LED on (HIGH is the voltage level)
  delay(1000);                       // wait for a second
  digitalWrite(LED_BUILTIN, LOW);    // turn the LED off by making the voltage LOW
  delay(1000);                       // wait for a second
}
Last update: March 3, 2022