// definitions

int REDLed = 10; //LED op mamaboard
int Sensor1 = 1; //sensor 1
int Sensor2 = 9; //sensor 2
int sensorValue1 = 0;
int sensorValue2 = 0;


void setup() {
  // Initialize serial communications at 9600 bps:
  Serial.begin(9600);
  while(!Serial);
  pinMode(REDLed, OUTPUT);
 pinMode(Sensor1, INPUT);
 pinMode(Sensor2, INPUT);
}//void setup

void loop() {
  sensorValue1 = digitalRead(Sensor1);
     
  int S1map_value = map(sensorValue1, 0, 1, 0, 100);

  Serial.println(S1map_value);

//for the red led sensor 1
  if (sensorValue1 == 0)               //if sensor reads 0
  {   
      digitalWrite (REDLed, LOW);
  }
  else                              //if sensor reads anything else then 0
  { 
    digitalWrite (REDLed, HIGH);
  }

delay(500);

sensorValue2 = digitalRead(Sensor2);

int S2map_value = map(sensorValue2, 0, 1, 0, 50);
  Serial.println(S2map_value);

   if (sensorValue1 == 0)               //if sensor reads 0
  {   
      digitalWrite (REDLed, LOW);
  }
  else                              //if sensor reads anything else then 0
  { 
    digitalWrite (REDLed, HIGH);
  }
  delay(500);
}//void loop