<B>Wide Plastic Gull Wing Small Outline Package</B> >NAME >VALUE <b>RESISTOR</b> >NAME >VALUE <b>RESISTOR</b><p> wave soldering >NAME >VALUE >NAME >VALUE <b>SOT 23</b> >NAME >VALUE 1 >NAME >VALUE <b>PIN HEADER</b> >NAME >VALUE 1 <b>CAPACITOR</b> >NAME >VALUE <b>Ceramic Chip Capacitor KEMET 1206 reflow solder</b><p> Metric Code Size 3216 >NAME >VALUE >NAME >VALUE 1 >NAME >VALUE <b>Hyper TOPLED® </b><p> Source: http://www.osram.convergy.de/ >NAME >VALUE R A B G LED 1206 pads (standard pattern) >NAME >VALUE LED1206 FAB style (smaller pads to allow trace between) >NAME >VALUE 5mm round through hole part. >NAME >VALUE >NAME ATtiny45 >NAME >VALUE >NAME >VALUE >NAME >VALUE MISO SCK RST VCC MOSI GND >NAME >VALUE >NAME >VALUE >NAME >VALUE LED >NAME >VALUE <b>Resistor (US Symbol)</b> <p> Variants with postfix FAB are widened to allow the routing of internal traces <b>OSRAM</b><p> <u>Hyper Multi TOPLED® Hyper-Bright LED</u><br> LATB T686<br> <p> Source: http://www.osram.convergy.de/ LED <b>Supply Symbols</b><p> GND, VCC, 0V, +5V, -5V, etc.<p> Please keep in mind, that these devices are necessary for the automatic wiring of the supply signals.<p> The pin name defined in the symbol is identical to the net which is to be wired automatically.<p> In this library the device names are the same as the pin names of the symbols, therefore the correct signal names appear next to the supply symbols in the schematic.<p> <author>Created by librarian@cadsoft.de</author> >VALUE >VALUE <b>SUPPLY SYMBOL</b> <b>SUPPLY SYMBOL</b> <b>Pin Header Connectors</b><p> <author>Created by librarian@cadsoft.de</author> <b>PIN HEADER</b> >NAME >VALUE <b>PIN HEADER</b> >NAME >VALUE PIN HEADER PIN HEADER >NAME >VALUE <b>PIN HEADER</b> Since Version 8.2, EAGLE supports online libraries. The ids of those online libraries will not be understood (or retained) with this version. Since Version 8.3, EAGLE supports URNs for individual library assets (packages, symbols, and devices). The URNs of those assets will not be understood (or retained) with this version. Since Version 8.3, EAGLE supports the association of 3D packages with devices in libraries, schematics, and board files. Those 3D packages will not be understood (or retained) with this version.