Electronic Design

In electronic there many software to use for designing PCBs. I did prefare to use the one most of my colleagues were using which is CAD soft Eagle to make PCBs.

I started by learning basics of the software before I designing, I thank my colleagues to help during the process of the assignement.

I first designed a schematic of the circuit by placing component I want to use.

After designing the schematic, I continued to design the PCB.

This part was the most difficult to be able to place componets the right way.

After place all components I used autoroute since cause I found it easier.

This is the final look of the PCB design.

I exported an image of the PCB board and converted it in RML file for using in roland monofab.

At this point I had my design ready to be milled.

After milling I assembed my component so I can start soldering them.

I started to solder each component in its place.

This is how the board looks after soldering it.

I also programmed the board after soldering it.

Files used can be downloaded Here