Group Assignment

02

Individual Contribution

03

I proposed the idea that makes a sand track in this week. that uses a metallic wait that makes prtrones i draw on sand.since in the fablab they had a damaged 3d printer but the electronic components served.

I made a sketch of the idea in fusion 360 and how the machine was shaped, it is made up of two tray, one for the sand and the other for the mechanism system (COREXY).

After peter disassemble the damaged printer, the measurement of the motors was taken, cylinder to make the pieces in 3d.

the 3d pieces after designing it I put it to print.

I did a test where the engines went perfectly to the pieces.

The cylinder fit into the hole of the pieces.

I put all the pieces to make a stability test and they are aligned

and here helping to assemble the belt and the bearing.

after finishing to assemble the machine with the bearing, belt and the magnet. the machine can move manualy.