/*
  Software serial multple serial test

 Receives from the hardware serial, sends to software serial.
 Receives from software serial, sends to hardware serial.

 The circuit:
 * RX is digital pin 10 (connect to TX of other device)
 * TX is digital pin 11 (connect to RX of other device)

 Note:
 Not all pins on the Mega and Mega 2560 support change interrupts,
 so only the following can be used for RX:
 10, 11, 12, 13, 50, 51, 52, 53, 62, 63, 64, 65, 66, 67, 68, 69

 Not all pins on the Leonardo and Micro support change interrupts,
 so only the following can be used for RX:
 8, 9, 10, 11, 14 (MISO), 15 (SCK), 16 (MOSI).

 created back in the mists of time
 modified 25 May 2012
 by Tom Igoe
 based on Mikal Hart's example

 This example code is in the public domain.

 */
#include <SoftwareSerial.h>
#define rxPin A2
#define txPin A3

int firstByte = 0;
int secondByte = 1;
int thirdByte = 2;

SoftwareSerial mySerial(A2, A3); // RX, TX

void setup() {

  pinMode (rxPin, INPUT);
  pinMode (txPin, OUTPUT);
  
  // Open serial communications and wait for port to open:
  mySerial.begin(57600);
  while (!mySerial) {
    ; // wait for serial port to connect. Needed for native USB port only
  }


  mySerial.println("Goodnight moon!");

  // set the data rate for the SoftwareSerial port
  mySerial.begin(4800);
  mySerial.println("Hello, world?");
}

void loop() { // run over and over
  if (mySerial.available()) {
    mySerial.write(mySerial.read());
  }
  if (mySerial.available()) {
    mySerial.write(mySerial.read());
  }
}