I completed machanical task such as how that assembly fitted on cart and connections where to put batteries
and circuit fitted.
next task was motors, that is the main part of this project. How much load the motor lift? What should be the
starting tourq? revolution per second. I have one gear motor. I planned to tested on it.I attached one end of
string to the pully on motors shaft and other end to bucket having waight of 6.5kg & connect motor to battery.
Weight is lifted very smoothly by the motor. Initial tourq was ok. revolutions are sufficient. i decided to use
that motor

What has worked?

I made electronics boards for wireless communication. Initially is was not worked. I stick with it. Checked all
possibilities regarding with board. But there were no issue with the board. Communication held between that two
boards, Receiver and transmitter means only got indication.

What hasnt Work?

Even if valid transmission done I didnt get the output. I held with this trying to repair the board but it wasnt
worked

what question need to be resolved?

To implement there were certain questiuons that need to be answer Such as Racing Bulls behavior, Physical straingth,
how owners take care of bulls? To know weither it is same as ordinary bull or not. And some questions around my project
I asked to many owenrs, 50% of them has positve response rest of told mi it is impossible.

What you have learned?

I learnt how to work on any project. How to anlysize track towords project development. I learned lot of things that I have
utilized all fab machines while performing final project. I learnt electronics, communication weither it is wired of wireless.
what parameters should check to when finalizing componants.
I learnt to deal with microcontroller which was my weak part. This is my great achievement during this Fab Academy. So
now I can read the any microcontroller read in the sence.I can track the fuction of IC. I can anlysize timing diagram.