FAB ACADEMY 2015-Paul Rutto 
FAB ACADEMY 2015-Paul Rutto This week's task was to add an input device to a microcontroller and progam it to do something.I added LED to the LED board i made and program to flash .
The schematic diagram of an output
Generated board with the components i used ( R1-10K,R2-1K, LED,capacitors 20 micro farad,1micro,attiny 13 microcontroler,6 pin connector
The LED board circuit connected to the programmer and computer,i programmed it to flash green light but it was dim light that it could be seen by the camera as shown below.
The program
