Vinyl Cutter
Fablab Amsterdam Logo
Bits
Using software : Illustrator
Atoms
Machine : Roland Camm-1 Servo
Material : Blue Vinyl
Comment :
When I peel a vinyl, I couldn't do finely.
I think I had to adjust power more strongly.
Using software : Illustrator
Machine : Roland Camm-1 Servo
Material : Blue Vinyl
Comment :
When I peel a vinyl, I couldn't do finely.
I think I had to adjust power more strongly.
Using software : Illustrator
Material : Plywood(3mm)
Machine : Laser Cutter
Using software : Kokopelli and Illustrator
Comment :
I'm going to use a 3mm plywood. So I made this module to become 3mm between crevices.
I'd like to connect same parts, and making big product like a Lego.
When I miss to connect, I've made different design.
If it makes matters worse, I'm going to adjust size of design.
Material : Plywood(3mm)
Machine : Laser Cutter
Comment :
When I adjust size of crevice "2.8", I thought is was a little narrow.
When I adjust size of crevice "2.9", these were a loose knot.
I think it had to adjust there to be 2.85.
But I could make to braid something like that.
Using software : Kokopelli and Illustrator
Comment :
I'm worried about that this module will brake.
Because its parts is very sinn.
Material : Plywood(3mm)
Machine : Laser Cutter
Comment :
I was trying to make very sinn modules,
But these broke for sinn.
So I was connecting different modules.
I cut materials 2.85mm and built it. I think these lose a little. Also I set laser, power is 100, speed is 2.0. So any materials wasn't cut, these were connected. I think I had to set speed which is slower than "2.0".