☰
Fab Academy
Yunje Choi

Computer-Aided Design


illustrator

I drew a picture of myself And puppy using an illustrator


  • The illustrator was simple enough to design in 2D.
    • git



  • I put the picture next to canvas. Because I'm not good at drawing
    • git



    git



    Fusion 360

    I tried 3D modeling through fusion 360.


    I designed a chair.

    You can check the tutorial videos by following the link below.

    Chair Modeling - Pipe


    Start by drawing a sketch Determine detailed dimensions and finish sketching.

    git



    Create a 3D model using Extrude.

    git



    And sketch again.

    git



    And Create a 3D model using Extrude.

    git



    Use a pipe to make the leg of the chair

    git



    git



    git



    git



    Sketch the portion of the pedestal through the project.

    git



    git



    git



    git



    git



    git



    git



    git



    git



    >And Create a 3D model using Extrude.

    git



    >Use a fillet to make the angled part round.

    git



    git



    Finally, it gives texture.

    git



    git



    Part of the final project was modeled in 3D during 3D scanning and printing.

    3D Scanning and Printing here<

    Fusion 360 File1 here

    Fusion 360 File2 here