This week we had 2 assignments one was the group assignment and the other was the individual assignment.

The group assignmnt were to test the design rules for your 3D printer.

The 3D printer we are using at our lab is Ultimaker 2+.

For the group assignment we printed a design to test the design rules for ultimaker 2+.

For printing this it took around one and half hours

For the individual assignment we had to design and 3D print an object.

The constraints for the 3d print design is that it should be small,a few cm cubeand should be limited by printer time.

The main thing to keep in mind was that the object should be non-subtractive,means we should design an object which can be simply milled.

For designing i used the software Fusion 360.

I planned to design a simple whistle without a ball inside it.